Standard Equipment

• 40 Ton rotating hydraulic wrecker
• 128" sliding boom, "V" shaped boom
• Anti-twist device
• Self leveling
• Computer controlled hydraulic system
• Wireless proportional remote control
• Visual and audio alarm to prevent roll-over
• Locks on sliding and rotating system
• "L" shaped mounting plate T1 steel
• Dual 35,000lbs planetary two speeds hydraulic winches
• 3/4" x 200' steel cable on each drum
• Air clutch release on winches
• Cable tensioners
• Two tandem hydraulic pump (one direct & one remote mounted)
• Dual 6 1/2" bore x 57" cylinder for power boom elevation
• Lock & safety valve on elevation cylinder
• Two stage power boom extension
• Directional boom sheave
• Nylon slide on boom
• Dual independent front & rear outriggers
• Lock & safety valve on each cylinder of hydraulic jack legs

• Lubrication fittings on all moving parts
• Dual controls
• Lights in lever controls
• 4 pressure gauges
• Heavy duty body 100" wide
• Door checks & hold backs
• 48" Tunnel toolbox + Two toolboxes (24 Cubic Ft.)
• 240" C.A. (from cab to center of rearmost axle)
• Hi-tensile steel used for structural parts
• Work lights in toolboxes
• Sandblast + Epoxy primer paint
• Undercoating underneath the body
• Monocoque body
• Rear mounted recovery anchors
• Recovery anchors on each outrigger for side pulling
• Recovery anchors on rear outriggers
• Federal standard #108 light group
• Safety chains (2 - 3/8 " x 15' grade 7)
• Air plug (truck must have trailer air system)
• Electric plug
• Mud flaps

• Reinforcement plate under the cab
• Reinforcement plate under the cab & bunk
• Third stage boom
• Super heavy duty axle-lift + 4 sets of forks + tie down chains
• Longer tunnel tool box 52" or 56" or 60
• Battery box inside the tunnel toolbox
• Light pylon
• Aluminum cover inside the light pylon
• Winch covers
• Aluminum checker plate on top of tunnel toolbox
• Aluminum checker plate on rear steps

• 2 Work lights under the bumper
• Stainless on boom
• Stainless on mast
• Stainless on light pylon
• Stainless on bottom of body
• Stainless on winch covers
• Stainless on lever controls
• Stainless on top of body's sides
• One-color paint (acrylic enamel)
• One-color paint (IMRON)
• Installation (includes PTO)